SSP 094 Diagnosis of the automatic gearboxes 0AM and 02E

Diagnosis of the automatic gearbox 0AM

Introduction

The following operating modes are available in the diagnostic unit VAS:

  • controlled fault finding
  • controlled functions

The gearbox electronics enables the following functions:

  • Identification services (information regarding the installation)
  • Coding of the gearbox control unit (code 20 for 02E and 0AM)
  • Reading the measured values
  • Basic setting - complete (checking the shifting of the gears, setting the engagement point on the clutches)
  • Basic setting - neutral (only before replacing the mechatronics, all the adjusters must be in the neutral position)
  • Modification
  • Fault storage in the event memory
  • Processing the measured values and their display in the measured value block

Shifting into the basic setting is carried out in accordance with:

  • the mechatronics assembly
  • the gearbox assembly
  • the selector lever assembly
  • the installation of other control units (e.g. engine control units), ABS or diagnostic interface for data buses (Gateway)