Contents

SSP 094 Diagnosis of the automatic gearboxes 0AM and 02E

Faults of the gearbox 02E and their rectification

List of common faults

  • 1a. – Uncomfortable sensation when shifting gears (Octavia II, Superb II)
  • 2a. – Paradoxical shifting
  • 3a. – Malfunction of the shifting
  • 4a. – Failure of the power transmission to the wheels
  • 5a. – Incorrect downshifting of the gearbox
  • 6a. – Delayed acceleration

1a. Uncomfortable sensation when shifting gears (Octavia II, Superb II)

Assessment:

  • While driving or when shifting the individual gears, uncomfortable shifting, jerking, jolting, etc. occur.
  • In most cases no fault is stored in the event memory of the gearbox control unit.

Cause:

This is an internal fault of the mechatronic gearbox control unit.

Solution:

  • Checking the manufacturing date of the mechatronics. Test procedure:

Self-diagnosis, 02 - Gearbox 011 - Measured value block - channel 54 H07 A0001 - J21 N0560 H = Year 2007; 07 = Calendar week J = Year 2008; 21 = Calendar week

TPI 2022347 issued

Determine if the manufacturing date falls in the previous time period (H07 – J21), if so replace the mechatronics. After replacing it, perform the basic setting and carry out a test drive.

2a. Paradoxical switch-over.

Assessment:

  • If the speed is reduced abruptly when braking (e.g. from 130 km/h to 80 km/h) the automatic gearbox shifts down into third or second gear when in the operating mode D or S. At this moment, the engine speed increases and will remain above 3000 rpm for a few seconds. A similar phenomenon may also occur when braking, while rolling to an intersection, if the gearbox downshifts into first gear and the engine speed temporarily increases.

Solution:

TPI 2025846 issued

On vehicles with ESP control unit with the index ... 379A replace the sender G419 (without G251) with the sender G419 (with G251).

3a. Malfunction of the shifting.

Assessment:

  • malfunction of the automatic gearbox
  • the display of the engaged gears disappears sporadically in the Maxi-Dot
  • the engaged gear cannot be changed
  • jerks can be felt when in operating mode "D"
  • after shifting into "R", the vehicle does not drive
  • the fault 19143 004 is stored in the fault memory of the gearbox; P2711 - Gearbox control unit without signal/ communication stored

Solution:

TPI 2024152 issued

Replacing the clutch set

4a. Failure of the power transmission to the wheels.

Assessment:

  • The gearbox control unit detects an incorrect clutch temperature and evaluates it as a clutch overload. Consequently, the safety function of the clutch is activated (the display showing the shifting flashes, the vehicle jerks, the engine torque drops and the clutch switches off).

Solution:

Maintenance intervention 37F2

Updating the SW of the gearbox control unit

5a. Incorrect downshifting of the gearbox.

Assessment:

  • Vehicle model:
    Octavia II MY 2007-2009, Superb II MY 2008-2009
  • When gear D4 is engaged (1500-2500 rpm), and the cruise control is activated, the gearbox shifts down into D2 (4000 rpm).
  • After switching off the cruise control, the gearbox shifts back into D4.

Solution:

Updating online and via diagnostic address 02

6a. Delayed acceleration.

Assessment:

  • Vehicle model: Octavia II MY 2006–2011, Superb II MY 2008–2011, Yeti MY 2009–2011
  • After deceleration (e.g. when rolling to an intersection) and subsequent acceleration, the engine speed increases and the vehicle drives off with delay.
  • When shifting manually into tiptronic mode (3-2, 4-3 or 5-4), the engine speed increases and the vehicle reacts again with delay.

Solution:

Updating online and via the engagement code (see table).

Table of engagement codes

Vehicle modelEngagement code
Octavia II308A
Octavia II China308B
Superb II308C
Yeti308D
Yeti RUS3091