1.6 TDI CR engine (EA189) · Glow plug system · Glow plug system
Removing and installing Hall sender G40
Removing
- Remove engine cover panel ⇒ 3 Engine cover panel.
- Remove fuel filter with bracket ⇒ Rep. gr. 20; Fuel filter; Removing and installing fuel filter.
- Remove poly V-belt ⇒ 13 – Crankshaft group.
- Remove front right wheel housing liner.
- Remove vibration damper ⇒ 1.4 Removing and installing vibration damper.
Polo
- Remove engine bracket ⇒ 1.8.4 Removing and installing engine bracket, Polo.
Continued for all vehicles
During further work, toothed belt must be removed from idler roller and high-pressure pump.
Removing toothed belt from idler roller and high-pressure pump ⇒ 2.2 Removing and installing toothed belt.

- Disconnect connector -1- for Hall sender - G40- and pull connector out of retainer.
- Detach plug from its retainer.

- Unscrew Hall sender - G40- -arrow-.

- Remove webs and repair aperture cover -arrows- with a screwdriver.
- Remove Hall sender - G40- from cylinder head and guide its plug through repair aperture in toothed belt guard.
Installing
Install in reverse order. During this procedure, observe the following:
- Seal repair aperture in toothed belt guard with rubber plugs as specified in ⇒ Electronic Parts Catalogue (ETKA).
- Fit toothed belt and adjust valve timing ⇒ 2.2 Removing and installing toothed belt.
Polo
- Install engine bracket ⇒ 1.8.4 Removing and installing engine bracket, Polo.