1.6 TDI CR engine (EA189) · Glow plug system · Glow plug system

Removing and installing glow plug

Special tools and workshop equipment required

Removing and installing glow plug: drawing 1
  • 10 mm jointed spanner - 3220-
Removing and installing glow plug: drawing 2
  • Pliers - 3314-

Removing

  • Switch off ignition.
  • Remove engine cover panel ⇒ 3 Engine cover panel.
  • Remove noise insulation at injectors.
  • Clean glow plug channel in cylinder head; make sure no dirt gets into cylinder.

Otherwise the whole wiring harness will need to be renewed.

Do not squeeze the pliers - 3314- too firmly when pulling off glow plug connectors, because otherwise the support sleeve may be damaged.

Removing and installing glow plug: drawing 3
  • Pull connector -B- off pressure differential sender - G 505- and fuel pressure sender - G 247- -C-.
Removing and installing glow plug: drawing 4
  • Open cable guide fasteners to free wiring harness.
Removing and installing glow plug: drawing 5
  • Position pliers - 3314- with groove -arrow A- on support sleeve shoulder -arrow B- and pull plugs off glow pin plugs.
Removing and installing glow plug: drawing 6
  • Carefully pull connector off glow plug in direction of -arrow-.
Removing and installing glow plug: drawing 7
  • Unscrew securing nut of fuel return line from intake manifold, open clamp -arrow- and pull line off fuel rail.
  • Remove entire fuel return line and set it down in front of intake manifold.
Removing and installing glow plug: drawing 1
  • To loosen glow plugs use special tool U/J extension and 10 mm socket - 3220-

Installing

  • To tighten glow plugs use special tool U/J extension and 10 mm socket - 3220- with a suitable torque wrench.
  • Then tighten glow plugs to specified torque.
  • Specified torque is 18 Nm
  • Fit glow plug connectors onto glow plugs and ensure they are properly seated.
  • Open cable guide fasteners to free wiring harness.
  • Secure wiring harness in cable guide again.
  • Continue installation in reverse order of removal.
  • Clear engine control unit event memory.

Tightening torques on this page

1 torque

In the steps

StepTorque
Specified torque is 18 Nm18 Nm

All tightening torques in this manual →