1.4 TSI engine (EA111) · Mixture preparation – injection · Intake manifold

Removing and installing regulating flap control unit J808 and throttle valve module J338

Special tools and workshop equipment required

Removing and installing regulating flap control unit J808 and throttle valve module J338: drawing 1
  • Torque wrench - V.A.G 1410-
Removing and installing regulating flap control unit J808 and throttle valve module J338: drawing 2
  • Hose clamp pliers - VAS 6340-

Removing regulating flap control unit - J808-

Removing and installing regulating flap control unit J808 and throttle valve module J338: drawing 3
  • Lift engine cover panel at points -1- and pull it forwards in direction of -arrow-.
  • Remove securing bolts -1-.
Removing and installing regulating flap control unit J808 and throttle valve module J338: drawing 4
  • Pull off all connectors and hose connections on intake connecting pipe -4- and regulating flap control unit - J808-.
  • Detach spring-type clips and pull off hose -2- on activated charcoal filter system solenoid valve 1 - N80- and pressure pipe -3-.
  • Unscrew securing bolt for pressure pipe -3- on turbocharger and pull pressure pipe -3- off.
Removing and installing regulating flap control unit J808 and throttle valve module J338: drawing 5
  • Unscrew intake connecting pipe securing bolts -arrows- and pull intake connecting pipe upwards with regulating flap control unit - J808-.
Removing and installing regulating flap control unit J808 and throttle valve module J338: drawing 6
  • Unscrew securing bolts -arrows-.

Removing throttle valve module - J338-

  • Detach coolant hose -1- from hose clips.
Removing and installing regulating flap control unit J808 and throttle valve module J338: drawing 7
  • Pull connector -2- off intake air temperature sender 3 - G520- with intake manifold pressure sender 3 - G583-.
  • Remove charge air hose -3- from throttle valve module - J338- and charge air pipe.
Removing and installing regulating flap control unit J808 and throttle valve module J338: drawing 8
  • Unscrew securing bolts -arrows- and pull throttle valve module - J338- from intake manifold connection.

Installing

Installation is carried out in the reverse order. When installing, note the following:

  • Seals and O-rings must be renewed and coated lightly with clean engine oil before installing.
  • Hose connections and hoses for charge air system must be free of oil and grease before assembly.
  • Secure all hose connections with hose clips which conform to production standard.
Removing and installing regulating flap control unit J808 and throttle valve module J338: drawing 9
  • Push engine cover panel down at points -1- in direction of -arrow- until it engages.

Specified torques:

Assembly overview - intake manifold ⇒ 2.1 Assembly overview - intake manifold.

If a new regulating flap control unit or throttle valve module has been installed:

  • Erase learnt values and adapt engine control unit - J623- to regulating flap control unit and throttle valve module ⇒ Vehicle diagnostic tester “Guided functions”.