1.4 TSI engine (EA111) · Cooling · Coolant pump, regulation of cooling system

Removing and installing coolant circulation pump V50 (Polo, Touran, Golf Plus, Eos, Tiguan, Scirocco, Golf, Golf Cabriolet)

Removing and installing coolant circulation pump V50 (Polo, Touran, Golf Plus, Eos, Tiguan, Scirocco, Golf, Golf Cabriolet): drawing 1

Special tools and workshop equipment required

  • Refractometer - T10007 A-
  • Hose clamp pliers - VAS 6340-
  • Torque wrench - V.A.G 1331-
Removing and installing coolant circulation pump V50 (Polo, Touran, Golf Plus, Eos, Tiguan, Scirocco, Golf, Golf Cabriolet): drawing 2
  • Hose clamps to 40 mm - 3093-

Removing

Golf Plus, Eos, Scirocco, Golf, Golf Cabriolet, Touran, Polo

  • Remove noise insulation ⇒ General body repairs, exterior; Rep. gr. 50; Body - front, noise insulation.

Tiguan

  • Depending on vehicle equipment, remove noise insulation or skid plate ⇒ General body repairs, exterior; Rep. gr. 50; Removing and installing noise insulation or skid plate.

Continued for all vehicles

  • Seal coolant hoses with hose clamps up to 40 mm - 3093-.
Removing and installing coolant circulation pump V50 (Polo, Touran, Golf Plus, Eos, Tiguan, Scirocco, Golf, Golf Cabriolet): drawing 3
  • Remove spring-type clips -arrows- and pull coolant hoses off.
  • Pull connector -1- off and remove securing bolt -2-.
  • Remove coolant circulation pump - V50- -3-.

Installing

Installation is carried out in the reverse order. When installing, note the following:

Specified torque for securing bolt: 10 Nm.

Tightening torques on this page

1 torque

In the steps

StepTorque
Specified torque for securing bolt: 10 Nm.10 Nm

All tightening torques in this manual →