7-speed DSG gearbox 0AM (DQ200) · Final Drive, Differential · Seals

Right Stub Shaft Seal, Replacing

Left side. Refer to ⇒ 1.3 Left Stub Shaft Seal, Replacing.

Special tools and workshop equipment required

  • Seal Installer - Flange Shaft - 3305-
  • Socket And Extended Bit - T10107A- or Long Hex Socket - VAG1669-
  • Used Oil Collection and Extraction Unit - SMN372500-
  • Sealing Grease - G 052 128 A1-

Removing

  • Remove the noise insulation below the engine/transmission. Refer to ⇒ Body Exterior; Rep. Gr. 50; Noise Insulation.
  • Remove the drive axle. Refer to ⇒ Suspension, Wheels, Steering; Rep. Gr. 40; Drive Axles, Removing and Installing.
  • Place the Used Oil Collection and Extraction Unit - SMN372500- or Drip Tray under the transmission.
Right Stub Shaft Seal, Replacing: drawing 1
  • Remove the bolt -arrow- in the stub shaft using the Socket And Extended Bit - T10107A- or Long Hex Socket - VAG1669-.
  • Remove the stub shaft.
  • Pry out the sealing ring.

Installing

  • Lightly oil the new gasket on the outer circumference.
Right Stub Shaft Seal, Replacing: drawing 2
  • Fill the space between the sealing and dust lip halfway with Sealing Grease - G 052 128- -arrow-.
Right Stub Shaft Seal, Replacing: drawing 3
  • Install the seal all the way in without tilting it.

If necessary, install a new dust ring on the stub shaft using Press Piece - Trailing Arm - 2010-. Do not use a hammer.

  • Insert the stub shaft.
  • Tighten the stub shaft bolt to 30 Nm. Push the stub shaft against the transmission so that the bolt engages in the thread.
  • Reinstall the drive axle. Refer to ⇒ Suspension, Wheels, Steering; Rep. Gr. 40; Drive Axles, Removing and Installing.
  • Refill any transmission fluid that may have leaked out while removing the seal. Refer to ⇒ 1 Transmission Fluid, Replacing.
  • Install the noise insulation. Refer to ⇒ Body Exterior; Rep. Gr. 50; Noise Insulation.

Tightening torques on this page

1 torque

In the steps

StepTorque
Tighten the stub shaft bolt to 30 Nm. Push the stub shaft against the transmission so that the bolt engages in the thread.30 Nm

All tightening torques in this manual →