7-speed DSG gearbox 0AM (DQ200) · Gears, Shafts · Parking Lock
Parking Lock, Removing and Installing
Removing
- The transmission is installed.

- Remove the cover from the parking lock -1-. Refer to ⇒ 2.1 Parking Lock Cover, Removing and Installing.

- Remove the bolts -2- and pull the parking lock -1- off the alignment sleeves -arrows-.
It the parking lock cannot be removed by hand:
- Mount Slide Hammer Set - VW771- with Slide Hammer Set - Hook - VW771/37- behind the parking lock and remove it by pulling alternating from side to side.
- Always replace the bolts -2-.
Installing
- Place the parking lock -1- on the alignment sleeves -arrows-.
- Install new bolts -2-.
- Install the cover for the parking lock -1-. Refer to ⇒ 2.1 Parking Lock Cover, Removing and Installing.
Tightening Specifications
| Component | Tightening Specification |
| Parking lock to the transmission housing • Replace the bolts after removing them. | 20 Nm +90° |
Tightening torques on this page
1 torque
| Part | Torque |
|---|---|
| Parking lock to the transmission housing • Replace the bolts after removing them. | 20 Nm +90° |