7-speed DSG gearbox 0AM (DQ200) · Gears, Shafts · Parking Lock

Parking Lock Cover, Removing and Installing

Special tools and workshop equipment required

  • Pry Lever - 80-200-

Removing

  • The transmission is installed.
  • The selector lever is in »P«.
  • Remove the air filter housing:
  • Gasoline engine. Refer to ⇒ Rep. Gr. 24; Air Filter; Overview - Air Filter Housing.
  • TDI engine. Refer to ⇒ Rep. Gr. 23; Diesel Direct Injection System; Overview - Air Filter.
Parking Lock Cover, Removing and Installing: drawing 1
  • Remove the battery and the battery tray -arrows-. Refer to ⇒ Electrical Equipment; Rep. Gr. 27; Battery; Battery, Removing and Installing.
Parking Lock Cover, Removing and Installing: drawing 2
  • Remove the lock washer -1- from the selector lever cable.

Always replace the circlip on the selector lever cable.

  • Remove the selector lever cable -2- from the ball head on the selector lever using, for example, a Pry Lever - 80-200-.
Parking Lock Cover, Removing and Installing: drawing 3
Parking Lock Cover, Removing and Installing: drawing 4
  • Remove the bolt -3- and remove the selector lever -4-.
  • Remove the bolts -2- and the parking lock cover -1-.

Installing

The parking lock cover must be replaced if there are leaks on the gearshift shaft seal or on the parking lock cover.

  • Clean the sealing surface and the parking lock cover -1-.
  • Install the parking lock cover -1- and the bolts -2-.
  • Install the selector lever -4- and the bolt -3-.
  • Adjust the selector lever cable. Refer to.

Further installation is performed in the reverse order of the removal.

  • Install the battery and the battery tray. Refer to ⇒ Electrical Equipment; Rep. Gr. 27; Battery; Battery, Removing and Installing.
  • Install the air filter housing:
  • Gasoline engine. Refer to ⇒ Rep. Gr. 24; Air Filter; Overview - Air Filter Housing.
  • TDI engine. Refer to ⇒ Rep. Gr. 23; Diesel Direct Injection System; Overview - Air Filter.

Tightening Specifications

ComponentTightening Specification
Parking lock cover to transmission housing8 Nm
Transmission selector lever to selector shaft.15 Nm

огромный архив документации по автомобилям Volkswagen, Skoda, Seat, Audi

Tightening torques on this page

3 torques

In the steps

StepTorque
Bolt tightening specification -arrows-: 8 Nm +90° additional turn.8 Nm +90°

PartTorque
Parking lock cover to transmission housing8 Nm
Transmission selector lever to selector shaft.15 Nm

All tightening torques in this manual →