1.4 TSI engine (EA211) · Cooling · Coolant pump, regulation of cooling system
Removing and installing radiator outlet coolant temperature sender - G83-
Special tools and workshop equipment required
- Drip tray for workshop hoist - VAS 6208-
- Socket AF 29 - VAS 262 003-
Removing
- Engine cold.
- Carefully open filler cap -1- on coolant expansion tank -2- in -direction of arrow-.
- To relieve residual pressure in cooling system, open filler cap -1- on coolant expansion tank -2- briefly and then close cap again (it should click into place).
- Place drip tray for workshop hoist - VAS 6208- underneath.
- Remove noise insulation ⇒ General body repairs, exterior; Rep. gr. 66; Noise insulation.
- Release and disconnect electrical connector -2- from radiator outlet coolant temperature sender - G83- -1-.
- Place a cloth underneath to catch escaping coolant.
- Unscrew radiator outlet coolant temperature sender - G83- -1- from radiator -3-.
- Unscrew radiator outlet coolant temperature sender - G83- using socket AF 29 - VAS 262 003-.
Installing
Install in reverse order of removal. The following should be observed:
- Install noise insulation at front ⇒ General body repairs, exterior; Rep. gr. 66; Noise insulation.
- Check coolant level ⇒ 1.3 Draining and adding coolant.
Torque settings