1.2 TDI CR engine (EA189) · Lubrication · Sump
Sump – assembly overview and fastening
- 1 Cylinder block
- 2 Seal
- Renew
- Must not be oiled.
- Fit into lugs on oil filter bracket.
- 3 Oil filter bracket with engine oil cooler
- Assembly overview ⇒ 3 Oil filter, oil pressure switch.
- 4 14 Nm + 90° (1/4 turn) further
- Renew
- 5 Oil dipstick
- The oil level must not be above the max. mark
- 6 9 Nm
- 7 Noise insulation
- 8 9 Nm
- 9 8 Nm
- 10 Charge air pipe
- 11 Sump
- Removing and installing ⇒ 1.3 Removing and installing sump
- 12 Bracket for coolant pipes
- 13 Bolt
- 10 Nm
- 14 Oil level and oil temperature sender - G266-
- Checking ⇒ Vehicle diagnostic tester
- 15 O-ring
- Renew
- 16 15 Nm
- 17 Oil drain plug, 30 Nm
- With captive seal
- Renew
- 18 5 Nm
- 19 Cover
- Balancer shaft module
- Clean if soiled.
- 20 Balancer shaft module with oil pump
- Renew only as complete unit
- Removing and installing ⇒ 5.1 Assembly overview - balancer shaft module
- 21 15 Nm
- 22 Sealing flange at belt pulley end
- Renew
- Must seat on dowel sleeves.
- Removing and installing ⇒ 1.9.2 Ancillary bracket (removing and installing)
Sump - specified torque and tightening sequence
| Stage | Bolts | Specified torque |
|---|---|---|
| 1) | -1 … 20- | In diagonal sequence to 5 Nm |
| 2) | -Arrows- | 40 Nm |
| 3) | -1 … 20- | Diagonally in stages; final torque 15 Nm |