1.2 TDI CR engine (EA189) · Lubrication · Oil filter, oil pressure switch
Oil filter bracket and engine oil cooler – assembly overview and fastening
- 1 Cap, 25 Nm
- 2 O-ring
- Renew
- 3 O-ring
- Renew
- 4 O-ring
- Renew
- 5 Oil filter element
- See note.
- Observe change intervals.
- 6 Engine oil cooler
- Ensure clearance to adjacent components
- Checking engine oil cooler for leaks ⇒ 3.1 Assembly overview - oil filter bracket and engine oil cooler
- 7 11 Nm
- 8 Rubber seals
- Renew
- Fit into lugs on oil filter bracket.
- May not be lubricated with oil
- 9 Bolt
- Renew
- Specified torque and tightening sequence ⇒ 3.1 Assembly overview - oil filter bracket and engine oil cooler
- 10 Oil filter bracket
- Ensure clearance to adjacent components
- 11 Rubber seals
- Renew
- Fit into lugs on oil filter bracket.
- May not be lubricated with oil
Oil filter bracket - specified torques and sequence
- First tighten upper left and lower right bolts.
- Tighten bolts in 2 stages:
| Stage | Bolts | Specified torque/turning further angle |
|---|---|---|
| 1) | -Arrows- | In diagonal sequence to 14 Nm |
| 2) | -Arrows- | turn 90° further diagonally |
Oil pressure switch - F1-
- With seal
- Switch pressure 0.3 to 0.6 bar
- Removing and installing ⇒ 3.3.2 Checking oil pressure
- Checking ⇒ 3.2 Removing and installing oil filter bracket with engine oil cooler
- 20 Nm