1.2 TDI CR engine (EA189) · Lubrication · Balancer shaft module
Balancer shaft module – assembly overview and fastening
- 1 Cover
- Clean if soiled.
- 2 8 Nm
- 3 14 Nm + 180° further
- Tighten in several stages.
- Tighten diagonally from inside to outside.
- 4 14 Nm + 180° further
- 5 Balancer shaft with oil pump
- Before installing, check that the dowel sleeves for centring oil pump on cylinder block are fitted and the O-ring is fitted in the retaining frame
- Removing and installing ⇒ 5.1 Assembly overview - balancer shaft module
- 6 O-ring
- Renew
- Check firm seating, inserted into retaining frame.
- Lightly coat with oil before installing
- 7 Cylinder block
- 8 Dowel sleeve
- 9 Chain tensioner with tensioning rail
- To remove, lock with locking pin - T40011-
- Removing and installing ⇒ 5.1 Assembly overview - balancer shaft module
- 10 8 Nm + turn 90° further
- Renew
- 11 Assembly aid
- Locking pin - T40011-
- 12 Chain
- Observe installation position ⇒ 5.1 Assembly overview - balancer shaft module, Removing and installing balance shaft
- 13 23 Nm
- 14 Chain sprocket/guide roller