1.2 TDI CR engine (EA189) · Cylinder head, valve gear · Cylinder head
Removing and installing vacuum pump
- Remove air filter housing with air mass meter and connecting pipe ⇒ 7.1 Assembly overview - air filter.
- Pull vacuum line -1- off vacuum pump -2-.
- Unscrew securing bolts of the charge-air pipe ⇒ Item 11 (page 179), then push charge-air pipe down slightly to gain access to rear threaded connection of vacuum pump.
- Unscrew vacuum pump securing bolts -arrows-.
- Remove vacuum pump -2- from cylinder head.
Installing
Specified torques ⇒ 1.2.3 Removing and installing injector seal in cylinder head cover
Installation is carried out in the reverse order. When installing, note the following:
- Install vacuum pump and tighten securing bolts to 10 Nm.
- Connect brake servo vacuum line to vacuum pump -1-.