1.2 TDI CR engine (EA189) · Cylinder head, valve gear · Cylinder head

Cylinder head – assembly overview and fastening

1 25 Nm
2 Lifting eye
3 Seal
- Renew
4 Vacuum pump
5 10 Nm
6 10 Nm
7 G 62
- Radiator outlet coolant
8 Coolant hose connection
9 O-ring
- Renew
10 Clip
11 25 Nm
12 Bracket
13 Cylinder head gasket
- Renew
- Observe identification ⇒ 1.3 Assembly overview - cylinder head.
- After renewing, renew entire coolant
14 Cylinder head
- Removing and installing ⇒ 1.3 Assembly overview - cylinder head.
- After renewing, renew entire coolant
15 Glow pin plug, 18 Nm
16 Cylinder head bolt
- Observe sequence when loosening and tightening ⇒ 1.3 Assembly overview - cylinder head.
- Before installing, insert washers into cylinder head.
17 Oil pressure switch - F1-, 22 Nm
- Identification: green
- 0.5 bar
- If seal is leaking, nip open and renew.
- Checking ⇒ 3.2 Removing and installing oil filter bracket with engine oil cooler

Checking cylinder head for distortion

Special tools and workshop equipment required

Max. permissible distortion: 0.1 mm

Cylinder head gasket identification