Removing and installing vibration damper

»Carry out the following work sequence«

Removing

• Remove poly V-belt ⇒ 13 – Crankshaft group.

• Unscrew coolant line bolts -arrows-.
• Move coolant lines aside slightly.
• Remove charge-air pipe »cold« side.
• Cover cap for vibration damper.

• Loosen bolts -arrows- for vibration damper, counterhold on crankshaft pulley bolt with a ring spanner to do this.

• Unscrew bolts and remove vibration damper.

Installing

Installation is in the reverse sequence of removal. The following should be observed:

Specified torques ⇒ Item 27 (page 84)

• Install vibration damper with new bolts ⇒ Electronic parts catalogue.

• The vibration damper can only be installed in one position. The hole in the vibration damper must be located over the projection on the toothed belt pulley -arrow-.