Removing and installing seat cover and seat cushion for seat pan

6C 2014–2017 Special tools and workshop equipment required

• Awl - V.A.G 1636-

• Torque wrench - V.A.G 1783-

Removing

• Remove front seat ⇒ 1.1 Removing and installing front seat.
• Removing front belt buckle ⇒ 1.5 Removing and installing front belt buckle.
• Removing seat trim on tunnel side ⇒ 1.2 Removing and installing seat trim on tunnel side.
• Removing seat trim on sill side:

• Seat without height adjustment ⇒ 1.3.1 Removing and installing seat trim on sill side, seat without height adjustment.
• Seat with height adjustment ⇒ 1.3.2 Removing and installing seat trim on sill side, seat with height adjustment.

• Removing mounting for drawer, if fitted ⇒ 1.6 Removing and installing mounting for drawer.

• Unscrew bolt -1- (3 Nm) and remove bracket -2-.
• Unclip clamped section -3- from seat frame -4-.
• Unclip seat heater connector, if installed, from retainer und seat.
• Unhook padding wire -1- from padding using awl - V.A.G 1636-.
• Take cover -2- and padding -5- ff seat frame.
• Remove cover.

Installing

Installation is carried out in reverse order.