Body interior · Seat – padding, covers · Rear seat covers and padding
Removing and installing rear seat backrest cover and padding
6C 2014–2017 Special tools and workshop equipment required
- Awl - V.A.G 1636-
Removing
- Remove bench seat ⇒ 2.1 Removing and installing bench seat / individual seats.
- Remove backrest ⇒ 2.2 Removing and installing rear seat backrest.
- Head restraint removed
- Unclip cover -1- from belt guide -2-.
- Lever belt guide -2- out of backrest using a screwdriver or a suitable plastic wedge.
- Lever covers -1- and -2- out of backrest using a screwdriver.
- On rear side of backrest -3-, unhook all cover profiles -6- from backrest beading.
- Roll up cover on sides.
- Carefully pull cover over head restraint guides.
- Take off cover and padding from backrest frame.
- Unhook all padding wires -4- and -5- from wire frame in padding using awl - V.A.G 1636-.
Installing
Installation is carried out in reverse order.
Covers -1- and -2- are fitted with a disposable catch. They must be renewed when installing.
- After installing padding and cover, check and make sure that covers -1- and -2- are completely engaged in backrest locking mechanisms.