Fitting hose connections with plug-in connectors

Removing:

• Release plug-in connector by pulling out retaining clip -arrow-. Separate hose/pipe without tools.

Installing

• If renewed, place seal in groove of charge air hose. Make sure that the seal is correctly seated in the groove all around the complete circumference and that it is not twisted.
• Lubricate sealing surface and seal with oil.

• Bring retaining clip to release position -1-.
• Push charge air hose into coupling to stop.
• Bring securing clip to locking position -2- and then push charge air hose again.
• Check if plug-in connector seats correctly and is properly engaged by pulling hose.