Removing and installing Hall sender - G40-

»Carry out the following work sequence«

• Remove toothed belt ⇒ 2.1.1 Removing and installing engine bracket.

• Separate connector Hall sender - G40- -arrow-.

• Loosen Hall sender - G40- bracket -arrow-.
• Remove connector from bracket.

• Unscrew Hall sender - G40- -arrow-.

• Use a screwdriver to remove webs and cover of repair opening -arrows-.
• Remove Hall sender - G40- from cylinder head. Guide connector through repair opening in toothed belt guard.

Installing

Install in reverse order. During this procedure, observe the following:

• Seal repair aperture in toothed belt guard with rubber plugs as specified in ⇒ Electronic parts catalogue (ETKA).

• Fit toothed belt and adjust the valve timing ⇒ 2.2.1 Removing.