Removing and installing knock sensor - G61-

⇒ 1.4.1 Removing

⇒ 1.4.2 Installing

1.4.1 Removing

»Carry out the following work sequence«

• Remove engine cover panel ⇒ 3 Engine cover panel

• Open clamps -3 and 5-.

Remove connection hose -4- from charge-air pipe »cold«, upper side.

• Pull connector -5- off throttle valve module - J338-.

• Remove throttle valve module - J338-.

• Disconnect connector of knock sensor - G61- -2-.
• Unscrew securing bolt -3- from the knock sensor.

1.4.2 Installing

Install in reverse order. During this procedure, observe the following:

Specified torque for securing bolt -3- of the knock sensor: 20 Nm.

Specified torque for throttle flap control module - J338- ⇒ 7.2 Removing and installing air filter housing.