Removing and installing engine speed sender - G28-

Special tools and workshop equipment required

• Hexagon key extension, 4 mm - T10370-

• Assembly tool - T10118-

• Remove noise insulation ⇒ General body repairs, exterior; Rep. gr. 50; Body - front; Assembly overview - noise insulation

• Disconnect electrical connector -1- at engine speed sender - G28- using assembly tool - T10118-.

• Loosen securing bolt -arrow-, and pull out engine speed sender - G28-.

Installation is performed in the reverse order, observing the following: specified torques for engine speed sender - G28- securing bolt: 5 Nm.