1.4 TSI engine (EA111) · Ignition system · Ignition system
Removing and installing engine speed sender - G28-
The engine speed sender - G28- is located on the sealing flange on the flywheel end of the crankcase.
Special tools and workshop equipment required
- Hose clamp pliers - VAS 6340-
- Torque wrench - V.A.G 1331-
- Guide pin - T10341-
- Locking pin - T10060 A-
- Allen key, long reach 5 mm - T10370-
Removing
- Remove compressor ⇒ 2.2 Removing and installing supercharger.
- Remove supercharger (Tiguan with four-wheel drive).
- Pull off connector -1- from engine speed sender - G28-.
- Remove gasket -2- from cylinder block and remove engine speed sender - G28- with socket - T10370-.
Installing
- Install engine speed sender - G28- and tighten securing bolt to 5 Nm.
Further assembly is basically a reverse of the dismantling sequence.