Silencers with mountings – assembly overview and fastening

• 1 Front silencer
• 2 25 Nm
• 3 Mounting
  • Observe installation position
• 4 Separation point
  • Marked by impressions on connecting pipe.
  • During production, front and rear silencers are installed as a single component. In case of repair, the front and rear silencers are supplied individually along with a double clamp.
  • Cut through connecting pipe with body saw e.g. body saw - V.A.G 1523A- at right angles at the separating point ⇒ 1.3 Assembly overview - silencers with mountings.
• 5 Rear silencer

Separating point on exhaust pipe

• Separate exhaust pipe at right angles at separating point -arrow 2-.
• When installing, position double clamp (repair solution) -4- at side markings -arrows 1 and 3-. Specified torque: 25 Nm