Equipment

2.1 Removing and installing sun visor

Removing

• Switch off ignition.
• Unclip cover cap -2- using a small screwdriver.
• Carefully pull sun visor bearing -1- out of mounting.

• Remove adhesive tape (used to minimise noise) and carefully disconnect connector -1- from sun visor -2- without pulling on flat cable.

Installing

• Install in reverse order of removal.
• Mask off connector to sun visor with adhesive tape to minimise noise.

2.2 Removing and installing roof grab handle

Special tools and workshop equipment required

• Release tool - T10517-

Removing

• Fold down grab handle -1- and open both cover caps.
• Press release tool - T10517- into both retaining clips to stop.
• Retaining clips are pressed together -arrows- and roof grab handle -1- can be removed.

Installing

• Clip grab handle into receptacles in roof and close both covers.