# 1.3 Installation position of clamp – 1.6 TDI CR engine (EA189)

> Installation position of clamp, 1.6 TDI (Exhaust pipes and silencers) on the VW Polo 6R: 2 steps, tightening torques and 4 drawings.

- Web page: https://catalog.polo.blue/repair-manuals/engine-1-6-tdi-cr-ea189/26-exhaust-system/installation-position-of-clamp/
- Original document: https://cdn.polo.blue/files/16-tdi-cr-engine-cayacaybcayc-workshop-manual-2019.pdf
- 26 – Exhaust system, [1.6 TDI CR engine (EA189)](https://catalog.polo.blue/repair-manuals/engine-1-6-tdi-cr-ea189/index.md)
- Previous procedure: [1.2 Aligning exhaust system free of stress](https://catalog.polo.blue/repair-manuals/engine-1-6-tdi-cr-ea189/26-exhaust-system/aligning-exhaust-system-free-of-stress/index.md)
- Next procedure: [2.1 Assembly overview – emission control](https://catalog.polo.blue/repair-manuals/engine-1-6-tdi-cr-ea189/26-exhaust-system/assembly-overview-emission-control/index.md)

![](https://catalog.polo.blue/manuals/vw-polo-engine-ea189-16-tdi-cr/0f5cdfb22b656d87.webp)

> **Note**
>
> Gradual introduction of clamp with continuous clip.

Specified torque and mounting dimensions of clamping sleeve.

Clamp -A- with 2 individual clips.

**Specified torque: 25 Nm**

Installation dimensions -a- 5 mm (only for front clamp)

Clamp -B- with continuous clip.

**Specified torque: 35 Nm**

Installation dimensions -a- 6.6 mm (only for front clamp)

![](https://catalog.polo.blue/manuals/vw-polo-engine-ea189-16-tdi-cr/f8e012b092b6300e.webp)

Installation dimension -a- for vehicles with marking on front exhaust pipe

- **1** Clamping sleeve
- **2** Front exhaust pipe

a - Installation dimension

**A - Marking**

![](https://catalog.polo.blue/manuals/vw-polo-engine-ea189-16-tdi-cr/f2b7158cb5770bd8.webp)

Installation position of front clamp

- Install clamp so that end of bolt -arrow- does not extend beyond lower edge of clamp.

- Threaded connection faces right

![](https://catalog.polo.blue/manuals/vw-polo-engine-ea189-16-tdi-cr/a29ebcd329ca2724.webp)

Installation position of rear clamp

- Install clamp so that end of bolt -arrow- does not extend beyond lower edge of clamp.

- Threaded connection faces to rear.

Specified torque: M8 = 25 Nm, M10 = 40 Nm 

## Tightening torques on this page

### In the steps
| Step | Torque |
| --- | --- |
| Specified torque: 25 Nm | 25 Nm |
| Specified torque: 35 Nm | 35 Nm |
| Specified torque: M8 = 25 Nm, M10 = 40 Nm | 25 Nm / 40 Nm |
