# 4.2 Checking changeover for exhaust gas recirculation cooler – 1.6 TDI CR engine (EA189)

> Checking EGR cooler changeover, 1.6 TDI on the VW Polo 6R: 3 steps. Reinstall heat insulation sleeve in the same location when assembling.

- Web page: https://catalog.polo.blue/repair-manuals/engine-1-6-tdi-cr-ea189/26-exhaust-system/checking-exhaust-gas-recirculation-cooler-changeover/
- Original document: https://cdn.polo.blue/files/16-tdi-cr-engine-cayacaybcayc-workshop-manual-2019.pdf
- 26 – Exhaust system, [1.6 TDI CR engine (EA189)](https://catalog.polo.blue/repair-manuals/engine-1-6-tdi-cr-ea189/index.md)
- Previous procedure: [4.1 Assembly overview – exhaust gas recirculation](https://catalog.polo.blue/repair-manuals/engine-1-6-tdi-cr-ea189/26-exhaust-system/assembly-overview-exhaust-gas-recirculation/index.md)
- Next procedure: [4.3 Removing and installing exhaust gas recirculation cooler](https://catalog.polo.blue/repair-manuals/engine-1-6-tdi-cr-ea189/26-exhaust-system/removing-installing-exhaust-gas-recirculation-cooler/index.md)

Special tools and workshop equipment required

![](https://catalog.polo.blue/manuals/vw-polo-engine-ea189-16-tdi-cr/f46b6f532c402830.webp)

- Hand vacuum pump - VAS 6213-

![](https://catalog.polo.blue/manuals/vw-polo-engine-ea189-16-tdi-cr/7333747520c7f10d.webp)

**Procedure**

- Remove heat shield sleeve.
- Detach vacuum hose from vacuum unit and connect hand vacuum pump - VAS 6213- in its place.
- Operate hand vacuum pump to create a vacuum.

- The linkage of the changeover for the exhaust gas recirculation cooler moves -arrows-.

If linkage does not move or only moves in jerks:

- Vacuum actuator is defective.
- Changeover flap for exhaust gas recirculation is tight.

> **Note**
>
> Reinstall heat insulation sleeve in the same location when assembling.
