# 7.2 Removing and installing air filter housing – 1.6 TDI CR engine (EA189)

> VW Polo 6R, step by step: removing and installing air filter housing, 1.6 TDI – 16 steps and 7 drawings.

- Web page: https://catalog.polo.blue/repair-manuals/engine-1-6-tdi-cr-ea189/23-mixture-preparation-injection/removing-and-installing-air-filter-housing/
- Original document: https://cdn.polo.blue/files/16-tdi-cr-engine-cayacaybcayc-workshop-manual-2019.pdf
- 23 – Mixture preparation - injection, [1.6 TDI CR engine (EA189)](https://catalog.polo.blue/repair-manuals/engine-1-6-tdi-cr-ea189/index.md)
- Previous procedure: [7.1 Assembly overview – air filter housing](https://catalog.polo.blue/repair-manuals/engine-1-6-tdi-cr-ea189/23-mixture-preparation-injection/assembly-overview-air-filter-housing/index.md)
- Next procedure: [8.1 Assembly overview – intake manifold](https://catalog.polo.blue/repair-manuals/engine-1-6-tdi-cr-ea189/23-mixture-preparation-injection/assembly-overview-intake-manifold/index.md)

[⇒ 7.2.2 Removing and installing air filter housing, Polo](https://catalog.polo.blue/repair-manuals/engine-1-6-tdi-cr-ea189/23-mixture-preparation-injection/removing-and-installing-air-filter-housing/#t448-678)

## 7.2.2 Removing and installing air filter housing, Polo

**Removing**

- Remove engine cover panel [⇒ 3 Engine cover panel](https://catalog.polo.blue/repair-manuals/engine-1-6-tdi-cr-ea189/10-removing-and-installing-engine/).

![](https://catalog.polo.blue/manuals/vw-polo-engine-ea189-16-tdi-cr/d1921202fff67eb6.webp)

- Release catches -arrows-, remove air duct -1-.

![](https://catalog.polo.blue/manuals/vw-polo-engine-ea189-16-tdi-cr/c6cb42c2c20fe17c.webp)

- Unclip bracket -arrows- together with vacuum hoses from air filter housing.

![](https://catalog.polo.blue/manuals/vw-polo-engine-ea189-16-tdi-cr/5ff6b8efd1e1b38d.webp)

- Disconnect connector -3-.
- Remove intake hose, loosening hose clip -2- to do so.
- Remove air hose; loosening hose clip -1- to do so if there is one.
- Unscrew bolt -4- and remove air filter housing.

**Remove suction hose**

> **Note**
>
> As it is difficult to gain access to clip on suction hose, it is better to remove intake connecting pipe from turbocharger.

![](https://catalog.polo.blue/manuals/vw-polo-engine-ea189-16-tdi-cr/dd480c3693a25b57.webp)

- Remove crankcase breather hose -3-.
- Pull vacuum hose -2- off intake hose -1- and move to side. Unclip bracket.
- Completely undo bolt -4- (make sure bolt is captive).
- Swing intake union to the right and remove with suction hose -1-.

**Install intake hose**

Installation is carried out in the reverse order. When installing, note the following: 

![](https://catalog.polo.blue/manuals/vw-polo-engine-ea189-16-tdi-cr/12db5992b1160336.webp)

- When mounting intake connecting pipe on turbocharger, it must be ensured that intake connecting pipe is correctly seated on the bolt of the turbocharger. -arrow-.

**Installing**

Install in reverse order.

When doing this, observe the following:

- Specified torques [⇒ 7.1.2 Assembly overview - air filter housing, Polo](https://catalog.polo.blue/repair-manuals/engine-1-6-tdi-cr-ea189/23-mixture-preparation-injection/assembly-overview-air-filter-housing/#t446-118).

> **Note**
>
> - A clean air filter housing is essential.
> - In order to avoid functional problems, you should cover the critical air-conducting components such as air mass meter, air pipes etc. with a clean cloth when blowing out the air filter housing with compressed air.
> - Hose unions and air intake pipes and hoses must be free of oil and grease before installation.
> - Use a silicone-free lubricant when installing air hoses.
> - Secure all hose connections with the correct type of hose clips (same as original equipment) ⇒ Electronic parts catalogue (ETKA).

- Check air intake hose for salt residue, dirt and leaves and, if necessary, clean.
- Check air duct leading from lock carrier to air filter housing for dirt and leaves. Clean if necessary.

Continue installation in reverse order of removal.

![](https://catalog.polo.blue/manuals/vw-polo-engine-ea189-16-tdi-cr/c087ae6d77f32932.webp)

- Guide water drainage pipe -arrow- between gearbox and body.

![](https://catalog.polo.blue/manuals/vw-polo-engine-ea189-16-tdi-cr/820bd25179e0c413.webp)

- Check under the wing to see whether the water drainage pipe has been installed correctly.
