# 1.3 Filling/bleeding fuel system – 1.6 TDI CR engine (EA189)

> Filling/bleeding fuel system, 1.6 TDI (Injection system) on the VW Polo 6R: 8 steps.

- Web page: https://catalog.polo.blue/repair-manuals/engine-1-6-tdi-cr-ea189/23-mixture-preparation-injection/filling-bleeding-fuel-system/
- Original document: https://cdn.polo.blue/files/16-tdi-cr-engine-cayacaybcayc-workshop-manual-2019.pdf
- 23 – Mixture preparation - injection, [1.6 TDI CR engine (EA189)](https://catalog.polo.blue/repair-manuals/engine-1-6-tdi-cr-ea189/index.md)
- Previous procedure: [1.2 Assembly overview – fuel system](https://catalog.polo.blue/repair-manuals/engine-1-6-tdi-cr-ea189/23-mixture-preparation-injection/assembly-overview-fuel-system/index.md)
- Next procedure: [1.4 Checking fuel system for leaks](https://catalog.polo.blue/repair-manuals/engine-1-6-tdi-cr-ea189/23-mixture-preparation-injection/checking-fuel-system-for-leaks/index.md)

> **Caution**
>
> Risk of irreparable damage to high-pressure pump if allowed to run dry.
>
> - The high-pressure pump must first be filled with fuel before the engine is started. Do not run the high-pressure pump while empty.

> **Note**
>
> - When installing the high-pressure pump, it is essential to ensure that no dirt enters the fuel system.
> - Only remove sealing plugs immediately prior to installation of fuel lines.
> - Vehicle must have fuel.

- Switch on ignition.
- Connect vehicle diagnostic tester and carry out guided function “Actuating fuel pump”.
- After completion of the function start the engine.
- After filling fuel system, leave the engine running at moderate speed for a few minutes and then switch it off again.
- Checking fuel system for leaks [⇒ 1.4 Checking fuel system for leaks](https://catalog.polo.blue/repair-manuals/engine-1-6-tdi-cr-ea189/23-mixture-preparation-injection/checking-fuel-system-for-leaks/#t392-598)
- Read out event memory and, if necessary, delete the event memory entry ⇒ Vehicle diagnostic tester.
- Test drive the vehicle extensively, accelerating to full throttle at least once. Then check high-pressure part of fuel system again for leakage.

> **Note**
>
> If there is still air in the fuel system, the engine can change to emergency running mode during road test. Switch off engine and clear event memory. Then continue with a road test.

- Read event memory again.
