# 1.4 Checking fuel system for leaks – 1.6 TDI CR engine (EA189)

> Checking fuel system for leaks, 1.6 TDI (Injection system) on the VW Polo 6R: 3 steps.

- Web page: https://catalog.polo.blue/repair-manuals/engine-1-6-tdi-cr-ea189/23-mixture-preparation-injection/checking-fuel-system-for-leaks/
- Original document: https://cdn.polo.blue/files/16-tdi-cr-engine-cayacaybcayc-workshop-manual-2019.pdf
- 23 – Mixture preparation - injection, [1.6 TDI CR engine (EA189)](https://catalog.polo.blue/repair-manuals/engine-1-6-tdi-cr-ea189/index.md)
- Previous procedure: [1.3 Filling/bleeding fuel system](https://catalog.polo.blue/repair-manuals/engine-1-6-tdi-cr-ea189/23-mixture-preparation-injection/filling-bleeding-fuel-system/index.md)
- Next procedure: [2.1 Connection diagram – vacuum system](https://catalog.polo.blue/repair-manuals/engine-1-6-tdi-cr-ea189/23-mixture-preparation-injection/connection-diagram-vacuum-system/index.md)

- Allow engine to idle for a few minutes but do not accelerate. Then switch off engine again. Fuel system will bleed itself automatically.
- Check fuel system for leaks.

Renew the affected component if leakage still occurs after tightening to the correct torque.

- Road-test the vehicle. Accelerate with full throttle at least once, then check the high-pressure section again for leaks.

> **Note**
>
> If there is still air in the fuel system, the engine can change to emergency running mode during road test. Switch off engine and clear event memory. Then continue with a road test.
