# 3.1 Assembly overview – injectors – 1.6 TDI CR engine (EA189)

> Injectors – assembly overview, 1.6 TDI on the VW Polo 6R: tightening torques and 1 drawing.

- Web page: https://catalog.polo.blue/repair-manuals/engine-1-6-tdi-cr-ea189/23-mixture-preparation-injection/assembly-overview-injectors/
- Original document: https://cdn.polo.blue/files/16-tdi-cr-engine-cayacaybcayc-workshop-manual-2019.pdf
- 23 – Mixture preparation - injection, [1.6 TDI CR engine (EA189)](https://catalog.polo.blue/repair-manuals/engine-1-6-tdi-cr-ea189/index.md)
- Previous procedure: [2.1 Connection diagram – vacuum system](https://catalog.polo.blue/repair-manuals/engine-1-6-tdi-cr-ea189/23-mixture-preparation-injection/connection-diagram-vacuum-system/index.md)
- Next procedure: [3.2 Adapting correction values for injectors](https://catalog.polo.blue/repair-manuals/engine-1-6-tdi-cr-ea189/23-mixture-preparation-injection/adapting-correction-values-for-injectors/index.md)

> **Caution**
>
> When installing a new short engine, it is compulsory to fix and tighten the clamping jaws of the injectors with the specified torque after installing the high-pressure lines [⇒ Item 20 (1.2.1 Assembly overview - fuel system, Polo)](https://catalog.polo.blue/repair-manuals/engine-1-6-tdi-cr-ea189/23-mixture-preparation-injection/assembly-overview-fuel-system/#t383-353). Clamping jaws are only secured »handtight« for setting the injectors while installing high-pressure lines. Non-observance of these notes may lead to damage to engine.

![](https://catalog.polo.blue/manuals/vw-polo-engine-ea189-16-tdi-cr/ef72e2bdfaccd5d3.webp)

- **1** Injectors
  - If they are to be reinstalled, the injectors, highpressure lines and clamping pieces must only ever be refitted on the same cylinder.
  - Before installing, clean injector bore using cleaning set - VAS 6811-
- **2** Bolt for clamp
  - Renew

Tighten securing bolts to a maximum of 1 to 2 Nm at first.

After the high-pressure lines have been fitted. Final specified torque: 8 Nm + turn 270° further.

- **3** High-pressure fitting
  - Counterhold when loosening the high-pressure lines
- **4** Return lines retaining clip
  - Do not reuse, renew
  - Grease the retaining clip lightly before installing the injector.
- **5** Copper washer
  - Renew
- **6** O-ring
  - Renew

## Tightening torques on this page

### In the steps
| Step | Torque |
| --- | --- |
| Tighten securing bolts to a maximum of 1 to 2 Nm at first. | 2 Nm |
| After the high-pressure lines have been fitted. Final specified torque: 8 Nm + turn 270° further. | 8 Nm |
