# 1.5 Removing and installing vacuum pump – 1.6 TDI CR engine (EA189)

> Removing and installing vacuum pump, 1.6 TDI (Cylinder head) on the VW Polo 6R: 7 steps, tightening torques and 2 drawings.

- Web page: https://catalog.polo.blue/repair-manuals/engine-1-6-tdi-cr-ea189/15-cylinder-head-valve-gear/removing-and-installing-vacuum-pump/
- Original document: https://cdn.polo.blue/files/16-tdi-cr-engine-cayacaybcayc-workshop-manual-2019.pdf
- 15 – Cylinder head, valve gear, [1.6 TDI CR engine (EA189)](https://catalog.polo.blue/repair-manuals/engine-1-6-tdi-cr-ea189/index.md)
- Previous procedure: [1.4 Removing and installing cylinder head cover](https://catalog.polo.blue/repair-manuals/engine-1-6-tdi-cr-ea189/15-cylinder-head-valve-gear/removing-and-installing-cylinder-head-cover/index.md)
- Next procedure: [1.6 Checking compression](https://catalog.polo.blue/repair-manuals/engine-1-6-tdi-cr-ea189/15-cylinder-head-valve-gear/checking-compression/index.md)

> **Danger**
>
> The vacuum pump may, under no circumstances, be dismantled as the vacuum part could otherwise malfunction. This would result in failure of the brake servo.

**Removing**

**Polo**

- Remove air filter housing together with air mass meter and connecting pipe [⇒ 7.2.2 Removing and installing air filter housing, Polo](https://catalog.polo.blue/repair-manuals/engine-1-6-tdi-cr-ea189/23-mixture-preparation-injection/removing-and-installing-air-filter-housing/#t448-678).

**Continued for all vehicles**

![](https://catalog.polo.blue/manuals/vw-polo-engine-ea189-16-tdi-cr/0d5d40f2c23fb26a.webp)

- Pull vacuum line -1- off vacuum pump -2-.
- Unscrew securing bolts of charge air pipe, and then push charge air pipe down slightly to gain access to rear threaded connection of vacuum pump.

![](https://catalog.polo.blue/manuals/vw-polo-engine-ea189-16-tdi-cr/0f13373de156427a.webp)

- Unscrew vacuum pump securing bolts -arrows-.
- Remove vacuum pump -2- from cylinder head.

**Installing**

Installation is carried out in the reverse order. When installing, note the following:

> **Note**
>
> - Ensure that vacuum pump coupling seats properly in camshaft.
> - Renew vacuum pump seal.

- Install vacuum pump and tighten securing bolts to 10 Nm.
- Connect brake servo vacuum line to vacuum pump -1-.

## Tightening torques on this page

### In the steps
| Step | Torque |
| --- | --- |
| Install vacuum pump and tighten securing bolts to 10 Nm. | 10 Nm |
