# 3.3 Measuring radial play of camshaft – 1.6 TDI CR engine (EA189)

> Measuring radial play of camshaft, 1.6 TDI (Valve gear) on the VW Polo 6R: 6 steps and tightening torques.

- Web page: https://catalog.polo.blue/repair-manuals/engine-1-6-tdi-cr-ea189/15-cylinder-head-valve-gear/measuring-radial-play-of-camshaft/
- Original document: https://cdn.polo.blue/files/16-tdi-cr-engine-cayacaybcayc-workshop-manual-2019.pdf
- 15 – Cylinder head, valve gear, [1.6 TDI CR engine (EA189)](https://catalog.polo.blue/repair-manuals/engine-1-6-tdi-cr-ea189/index.md)
- Previous procedure: [3.2 Measuring axial play of camshaft](https://catalog.polo.blue/repair-manuals/engine-1-6-tdi-cr-ea189/15-cylinder-head-valve-gear/measuring-axial-play-of-camshaft/index.md)
- Next procedure: [3.4 Removing and installing camshaft oil seal](https://catalog.polo.blue/repair-manuals/engine-1-6-tdi-cr-ea189/15-cylinder-head-valve-gear/removing-and-installing-camshaft-oil-seal/index.md)

Special tools and workshop equipment required

- Plastigage

**Procedure**

- Remove roller rocker finger.
- Remove bearing cap and clean crankshaft journal.
- Place a length of Plastigage corresponding to the width of the bearing on the journal to be measured or into the bearings.

- Plastigage must lie in the middle of the bearing.

- Fit retaining frame and tighten to 10 Nm [⇒ 3.1 Assembly overview - valve gear](https://catalog.polo.blue/repair-manuals/engine-1-6-tdi-cr-ea189/15-cylinder-head-valve-gear/assembly-overview-valve-gear/#t206-427) without twisting crankshafts.
- Remove retaining frame.
- Compare width of Plastigage with the measurement scale.

- Radial clearance: 0.035 to 0.085 mm.

## Tightening torques on this page

### In the steps
| Step | Torque |
| --- | --- |
| Fit retaining frame and tighten to 10 Nm ⇒ 3.1 Assembly overview - valve gear without twisting crankshafts. | 10 Nm |
