# 3.5 Measuring radial clearance of crankshaft – 1.6 TDI CR engine (EA189)

> Measuring radial clearance of crankshaft, 1.6 TDI on the VW Polo 6R: 6 steps and tightening torques.

- Web page: https://catalog.polo.blue/repair-manuals/engine-1-6-tdi-cr-ea189/13-crankshaft-group/measuring-radial-clearance-of-crankshaft/
- Original document: https://cdn.polo.blue/files/16-tdi-cr-engine-cayacaybcayc-workshop-manual-2019.pdf
- 13 – Crankshaft group, [1.6 TDI CR engine (EA189)](https://catalog.polo.blue/repair-manuals/engine-1-6-tdi-cr-ea189/index.md)
- Previous procedure: [3.4 Measuring axial clearance of crankshaft](https://catalog.polo.blue/repair-manuals/engine-1-6-tdi-cr-ea189/13-crankshaft-group/measuring-axial-clearance-of-crankshaft/index.md)
- Next procedure: [4.1 Assembly overview – pistons and conrods](https://catalog.polo.blue/repair-manuals/engine-1-6-tdi-cr-ea189/13-crankshaft-group/assembly-overview-pistons-and-conrods/index.md)

Special tools and workshop equipment required

- Plastigage 

**Procedure**

- Remove bearing cap.
- Remove bearing cap and clean bearing journal.
- Place a length of Plastigage corresponding to the width of the bearing on the journal or into the bearing shells.

- The Plastigage must lie in the middle of the bearing shell.

- Fit bearing cap and tighten bolts to 65 Nm without turning further angle and without rotating crankshaft.
- Remove bearing cap again.
- Compare width of Plastigage with the measurement scale.

Radial clearance:

- New: 0.03 to 0.08 mm
- Wear limit: 0.17 mm.

## Tightening torques on this page

### In the steps
| Step | Torque |
| --- | --- |
| Fit bearing cap and tighten bolts to 65 Nm without turning further angle and without rotating crankshaft. | 65 Nm |
