# 4.3 Measuring piston projection at “TDC” – 1.6 TDI CR engine (EA189)

> Measuring piston projection at “TDC”, 1.6 TDI (Pistons and conrods) on the VW Polo 6R: 3 steps, special tools VW 382/7 and VW 382 and 3 drawings.

- Web page: https://catalog.polo.blue/repair-manuals/engine-1-6-tdi-cr-ea189/13-crankshaft-group/measuring-piston-projection-at-tdc/
- Original document: https://cdn.polo.blue/files/16-tdi-cr-engine-cayacaybcayc-workshop-manual-2019.pdf
- 13 – Crankshaft group, [1.6 TDI CR engine (EA189)](https://catalog.polo.blue/repair-manuals/engine-1-6-tdi-cr-ea189/index.md)
- Previous procedure: [4.2 Removing and installing pistons](https://catalog.polo.blue/repair-manuals/engine-1-6-tdi-cr-ea189/13-crankshaft-group/removing-and-installing-pistons/index.md)
- Next procedure: [4.4 Separating new conrod](https://catalog.polo.blue/repair-manuals/engine-1-6-tdi-cr-ea189/13-crankshaft-group/separating-new-conrod/index.md)

> **Note**
>
> - Piston projection at “TDC” must be measured when installing new pistons or a short engine.
> - If you have measured the piston projection and it is not same for all pistons, use the highest value to determine the correct gasket size.
> - Install the appropriate cylinder head gasket depending upon piston projection, according to following table: 

![](https://catalog.polo.blue/manuals/vw-polo-engine-ea189-16-tdi-cr/b95be7d4fc40b979.webp)

Special tools and workshop equipment required

- Measuring bridge -VW 382/7- from measuring tool - VW 382-
- Measuring plate -VW 385/17- from universal measuring tool - VW 385-
- Dial gauge - VAS 6079- 

![](https://catalog.polo.blue/manuals/vw-polo-engine-ea189-16-tdi-cr/7f621a1f941a8eae.webp)

**Procedure**

- Secure dial gauge - VAS 6079- with measuring bridge - VW 382/7- and measuring plate -VW 385/17- to cylinder block as shown in the illustration.
- Measure the projection of each piston at the two points marked with -arrows- (at the rear side and front side of the piston seen in the longitudinal direction of the engine).
- Install the appropriate cylinder head gasket depending upon piston projection, according to following table:

| Piston projection over upper edge of cylinder block mm | Identification (No. of holes) |
| --- | --- |
| 0.91 … 1.00 | 1 |
| 1.01 … 1.10 | 2 |
| 1.11 … 1.20 | 3 |

![](https://catalog.polo.blue/manuals/vw-polo-engine-ea189-16-tdi-cr/72cb83b0691e25ca.webp)

**Cylinder head gasket identification**

- **1** Part number
- **2** Holes
- **3** Ignore

> **Note**
>
> If the measured values for piston projection are not the same for all pistons, use the highest value to determine the correct gasket size.
