# 4.5 Checking radial clearance of conrods – 1.6 TDI CR engine (EA189)

> Checking radial clearance of conrods, 1.6 TDI (Pistons and conrods) on the VW Polo 6R: 6 steps and tightening torques.

- Web page: https://catalog.polo.blue/repair-manuals/engine-1-6-tdi-cr-ea189/13-crankshaft-group/checking-radial-clearance-of-conrods/
- Original document: https://cdn.polo.blue/files/16-tdi-cr-engine-cayacaybcayc-workshop-manual-2019.pdf
- 13 – Crankshaft group, [1.6 TDI CR engine (EA189)](https://catalog.polo.blue/repair-manuals/engine-1-6-tdi-cr-ea189/index.md)
- Previous procedure: [4.4 Separating new conrod](https://catalog.polo.blue/repair-manuals/engine-1-6-tdi-cr-ea189/13-crankshaft-group/separating-new-conrod/index.md)
- Next procedure: [1.1 Assembly overview – cylinder head](https://catalog.polo.blue/repair-manuals/engine-1-6-tdi-cr-ea189/15-cylinder-head-valve-gear/assembly-overview-cylinder-head/index.md)

Special tools and workshop equipment required

- Plastigage

**Removing**

- Remove conrod bearing cap. Clean bearing cap and bearing journal.
- Place a Plastigage corresponding to the width of the bearing on the journal or into the bearing shells.
- Fit conrod bearing cap and tighten to 30 Nm without turning further angle and without rotating crankshaft.
- Remove conrod bearing cap again.
- Compare width of Plastigage with the measurement scale.

Radial clearance:

- Wear limit: 0.08 mm

- Renew conrod bolts.

## Tightening torques on this page

### In the steps
| Step | Torque |
| --- | --- |
| Fit conrod bearing cap and tighten to 30 Nm without turning further angle and without rotating crankshaft. | 30 Nm |
