# 3 Clutch-Side Seals, Removing and Installing – 7-speed DSG gearbox 0AM (DQ200)

> VW Polo 6R/6C, step by step: clutch-side seals of the DSG 0AM, removing and installing – 11 steps, special tools VW415A, T10420 and T10421 and 6 drawings.

- Web page: https://catalog.polo.blue/repair-manuals/dsg-gearbox-0am-dq200/30-clutch/clutch-side-seals-removing-and-installing/
- Original document: https://cdn.polo.blue/files/7-speed_dual_clutch_transmission_0am-eng.pdf
- 30 – Clutch, [7-speed DSG gearbox 0AM (DQ200)](https://catalog.polo.blue/repair-manuals/dsg-gearbox-0am-dq200/index.md)
- Previous procedure: [2.4 Dual Clutch, Installing, Transmission Production Date from 06/2011](https://catalog.polo.blue/repair-manuals/dsg-gearbox-0am-dq200/30-clutch/dual-clutch-installing-from-06-2011/index.md)
- Next procedure: [4 Special Tools](https://catalog.polo.blue/repair-manuals/dsg-gearbox-0am-dq200/30-clutch/special-tools/index.md)

Replacing the Input Shaft Seal

![](https://catalog.polo.blue/manuals/vw-polo-gearbox-0am-dsg/cb39b8f5c875aa7b.webp)

There are 2 seals in the transmission on the clutch side. It is possible to replace both seals -arrows- without disassembling the transmission. It is not necessary to adjust the clutch if only the seals are being replaced.

Special tools and workshop equipment required

- Press Piece - 60mm - VW415A-
- Puller - Shaft Seal - T10420-
- Seal Installer - Shaft Seal - T10421-
- Puller - Crankshaft/Power Steering Seal - T20143/2-

- Remove the transmission:

- Refer to
- Refer to [⇒ 5 Transmission, Removing and Installing, Jetta from MY 2011](https://catalog.polo.blue/repair-manuals/dsg-gearbox-0am-dq200/34-controls-housing/)

- Dual Clutch, Removing:

- through Transmission Production Date 05/2011. Refer to [⇒ 1 Dual Clutch, Removing and Installing, through Transmission Production Date 05/2011](https://catalog.polo.blue/repair-manuals/dsg-gearbox-0am-dq200/30-clutch/dual-clutch-removing-installing-up-to-05-2011/)
- from Transmission Production Date 06/2011. Refer to [⇒ 2 Dual Clutch, Removing and Installing, from Transmission Production Date 06/2011](https://catalog.polo.blue/repair-manuals/dsg-gearbox-0am-dq200/30-clutch/dual-clutch-removing-installing-from-06-2011/#t44-89).

> **Caution**
>
> Always check the clutch if there are leaks. The dual clutch must be replaced if it is covered with fluid.

![](https://catalog.polo.blue/manuals/vw-polo-gearbox-0am-dsg/b7cc2bc7d1655cf7.webp)

- Remove the outer seal.

![](https://catalog.polo.blue/manuals/vw-polo-gearbox-0am-dsg/181d9058e86a1346.webp)

- Drive in the outer, »new« seal flush to the clutch housing using a plastic mallet.

- The Press Piece - 60mm - VW415A- offset points upward -arrow-.

> **Warning**
>
> Install the seal flush with the clutch housing so that the oil bore behind it is not sealed. Otherwise the outer input shaft ball bearing will not have enough oil.

- Remove the Puller - Shaft Seal - T10420- spindle.

![](https://catalog.polo.blue/manuals/vw-polo-gearbox-0am-dsg/b0a6631acc2c99a4.webp)

- Install the Puller - Shaft Seal - T10420- on the »small«, inner seal. Press on the Puller - Shaft Seal when doing so.

The Puller - Shaft Seal will jam the seal when it is being turned It can be »felt« when the seal begins to move in its place.

![](https://catalog.polo.blue/manuals/vw-polo-gearbox-0am-dsg/572316cbc35537a5.webp)

- Now install the spindle.
- Remove the seal using the spindle.

![](https://catalog.polo.blue/manuals/vw-polo-gearbox-0am-dsg/4153edf9944b8505.webp)

- Drive in the »new« seal all the way.
- Dual Clutch, Installing:

- Through Transmission Production Date 05/2011. Refer to [⇒ 1.4 Dual Clutch, Installing, Transmission Production Date through 05/2011](https://catalog.polo.blue/repair-manuals/dsg-gearbox-0am-dq200/30-clutch/dual-clutch-installing-up-to-05-2011/#t37-82)
- From Transmission Production Date 06/2011. Refer to [⇒ 2.4 Dual Clutch, Installing, Transmission Production Date from 06/2011](https://catalog.polo.blue/repair-manuals/dsg-gearbox-0am-dq200/30-clutch/dual-clutch-installing-from-06-2011/#t62-82).

- Install the transmission:

- Refer to
- Refer to [⇒ 5 Transmission, Removing and Installing, Jetta from MY 2011](https://catalog.polo.blue/repair-manuals/dsg-gearbox-0am-dq200/34-controls-housing/)
