# 1.12 Removing and installing sliding sunroof adjustment control unit J245 – Body repairs – exterior

> Removing and installing sunroof control unit J245 on the VW Polo V: 10 steps, tightening torques and 3 drawings.

- Web page: https://catalog.polo.blue/repair-manuals/body-exterior/60-sunroof/removing-and-installing-sunroof-control-unit-j245/
- Original document: https://cdn.polo.blue/files/vw-polo-5-2014-body-repairs-exterior-eng.pdf
- 60 – Sunroof, [Body repairs – exterior](https://catalog.polo.blue/repair-manuals/body-exterior/index.md)
- Previous procedure: [1.11 Removing and installing front trim for sliding sunroof](https://catalog.polo.blue/repair-manuals/body-exterior/60-sunroof/removing-and-installing-front-trim-for-sliding-sunroof/index.md)
- Next procedure: [1.13 Removing and installing glass panel seal](https://catalog.polo.blue/repair-manuals/body-exterior/60-sunroof/removing-and-installing-glass-panel-seal/index.md)

Special tools and workshop equipment required

![](https://catalog.polo.blue/manuals/vw-polo-2014-body-exterior/5d29e4e115f0c941.webp)

- Torque wrench 210 Nm - V.A.G 1783-

**Removing**

> **Warning**
>
> Remove or install drive for panorama tilting sunroof glass panel only when sunroof is closed (“0” position ).

The requirements for removing and installing drive are: Engine not running and ignition off, key not in ignition and door open.

![](https://catalog.polo.blue/manuals/vw-polo-2014-body-exterior/72178d2947cc939c.webp)

Perform the following steps:

- Remove glass panel [⇒ 1.7 Removing and installing glass panel](https://catalog.polo.blue/repair-manuals/body-exterior/60-sunroof/removing-and-installing-glass-panel/#t200-614).
- If drive defective, remove glass panel [⇒ 1.8 Removing glass panel when drive is defective](https://catalog.polo.blue/repair-manuals/body-exterior/60-sunroof/removing-glass-panel-when-drive-is-defective/#t205-82)
- Remove cover [⇒ 1.15 Removing and installing cover](https://catalog.polo.blue/repair-manuals/body-exterior/60-sunroof/removing-and-installing-cover/#t227-682).
- Switch engine and ignition off, remove key and open door.

- This situation must be maintained until drive has been installed.

- Remove bolts -4- and pull off drive for panorama tilting roof -1-.
- Detach drive connector -5-.

**Installing**

> **Note**
>
> The bolts for the drive are microencapsulated and must always be renewed.

![](https://catalog.polo.blue/manuals/vw-polo-2014-body-exterior/9e452dddc3d5cf86.webp)

Perform the following steps:

- Plug in connector -5- at drive -1-.
- Check that the clips -2- are correctly seated.
- Fit drive -1-, and tighten bolts -4-. Specified torque: 4 Nm.
- After installation, the key can be inserted in ignition and starter switch again.

- Then test for proper function.

## Tightening torques on this page

### In the steps
| Step | Torque |
| --- | --- |
| Torque wrench 210 Nm - V.A.G 1783- | 210 Nm |
| Fit drive -1-, and tighten bolts -4-. Specified torque: 4 Nm. | 4 Nm |
